The top ten "tortures" for your pump:
Working too far from the rated design point for extended periods of time, whether in flow, pressure or speed, will damage your pump and shorten the life of the pump.
No. 2: Hunger
Never do pump maintenance, change grease/oil. Our Pump is like trucks, he needs frequent, periodic maintenance and upkeep.
No.3: Suffocation
1. Too low inlet liquid level;
2. The inlet pipe is not clean in the source water intake, and there is a blockage;
3. The temperature of the conveying medium has increased, but the inlet pressure has not increased; this will cause your pump to experience the pain of "suffocation".
No.4: Frying
Keeping your pump closed for long periods of time without any bypass, all system energy is wasted "heating" the water. The pump is like working in a frying pan, repeatedly "suffering".
No.5: Poisoning
The pumped medium has been changed without the approval of the equipment manufacturer. And this medium may corrode the casing material of the pump.
No.6: Piercing
For the source water with high sand content or the source water with poor water quality, there is no filtration and sedimentation equipment. These solid particles continuously flush the pump cavity and reduce the actual service life of the pump.
No.7: Anatomy
Because the outlet is blocked, or the inlet pressure is too high, the actual outlet pressure of the pump is much higher than its bearing pressure, and finally the pump is "exploded".
No.8: Trampoline
All pumps are installed on the same rigid foundation, or the foundation is too weak, and the foundation cannot provide sufficient strength, which restrains the running vibration of the pump, and the pump is like a trampoline, "jumping" non-stop.
No.9: Drowning
Before the pump is installed and debugged, it is in a humid environment; or after the pump is running, the drainage ditch is blocked, and the electrical components of the pump are exposed to water vapor for a long time.
No.10: Cold Violence
The pump is never given enough "care", the user does not inspect and regularly maintain the pump as required by the manufacturer, does not or rarely replace the seals or packing, does not repaint the pump, does not check for vibration, and keeps the pump from "small". Incurable disease” to “incurable serious disease”.
Back to list
